How do you drain the primary oil on an 883?
Take the bike for a few minutes ride to warm the primary fluid up.This will help drain the oil out better. Let the bike cool down for15 minutes. Locate the primary case on the left side of the engineand place an oil drain pan under it. Take a ratchet and a T-40 Torxbit and remove the drain bolt. Completely drain out the fluid intothe pan. Rocking the bike back and forth can help. Remove the drainplug and O-ring and clean them thoroughly. Place a new O-ring andput the drain plug back. Tighten the plug to foot pounds using atorque wrench. Remove the clutch inspection cover and the gasketusing aT-27 Torx bit. Replace the gasket if needed. Fill in primarycase with new fluid. Make sure it is level with the bottom springon the clutch assembly face. Put the back the inspection cover andgasket and tighten the bolts using a torque wrench in a starpattern to 10 foot-pounds. Clean up spilled fluid and check forleaks.
No comments:
Post a Comment